Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace Front Shock Absorbers on a Fiat

Model: Fiat Fiat Various
Part: Shocks

To replace the front shock absorber on a Fiat vehicle, you need to: remove the wheel after lifting the vehicle, first remove the top support plate of the shock absorber, then remove all the wiring and the 10 mm nut that holds the brake line above the brake disc. Use penetrating oil to loosen the two screws that hold the shock absorber to the hub; at this point, the shock absorber is free and can be extracted. Then take the kit that allows you to hold the spring tension and put tension on the spring itself. Next, remove the nut that secures the spring to the shock absorber (bump stop, bearing, and plate) so that you can extract the shock absorber from the spring. Take the new shock absorber and the new dust cover and reposition the plate with the corresponding bearing and bump stop, tighten the nut again and then release the spring tensioning kit. Finally, repeat all the operations in reverse to reassemble all the components.

Updated on 17 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Fiat Various To replace the button battery inside your Fiat Egea key, simply follow these steps. The entire procedure takes just a few minutes to complete and you…
Fiat Fiat Various If you don't know how to replace the front headlamp bulb on your new Fiat 595, simply follow the steps outlined in this guide. First, switch off the …
Fiat Fiat Various In today's video, you will see how to replace the casing of the remote control for Fiat models from the early 2000s. First, remove the manufacturer's…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos