|
Do it yourself
| |||
| ||||
|
Model: Gasgas Gasgas 300
Today, you will learn how to service the braking system and replace the rear brake pads on a 2003 Gasgas 300 motorcycle. Start by removing and replacing the rear brake pads; unscrew the caliper fixing screws and leverage inside the caliper to retract the piston as much as possible. Now remove the caliper and take out the central pin: remove the old pads and replace them with new, high-quality, correct-type pads. Clean the caliper of any carbon residues and reassemble all components!
Updated on 24 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Gasgas 300
Before starting, position and lift your GasGas 300 on a stand, then proceed to the rear wheel. Begin by loosening the fastening nut that adjusts the …
Gasgas 300
Before you begin, position your GasGas 300 on its side stand. Start by unscrewing and removing the two bolts that secure the exhaust end can to the r…
Gasgas 300
To replace the swingarm bearings on a Gasgas 300, you must first remove the swingarm itself. To do this, loosen the two bolts located near the sprock…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |