Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Gasgas
    3. : Fse 450

Model: Gasgas Fse 450
Part: Engine oil

To change the engine oil of the GasGas FSE 450, loosen the bolt located at the central lower part of the bike to collect the used oil in a suitably positioned container. Once all the oil has drained out, close the drain plug and remove the oil filter from its housing on the right side of the bike: this will allow you to insert a new replacement part and also top up with new oil. The new oil should be added through the breather on the right side of the bike.

Updated on 6 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you change the motor oil of the GasGas MC 450?
How do you change the motor oil of the GasGas MC 450?
Mc 450f To replace the motor oil of the GasGas MC 450, you need to loosen the drain plug located in the central lower part of the vehicle: once it has been r…
How do you replace the rear shock absorber of the GasGas EC 450?
How do you replace the rear shock absorber of the GasGas EC 450?
Ec 450 To replace the rear shock absorber of the GasGas EC 450, you need to loosen the screws that secure it to its housing: these screws will be located at…
How do you replace the rear shock absorber of the GasGas MC 450?
How do you replace the rear shock absorber of the GasGas MC 450?
Mc 450f In order to replace the rear shock absorber of the GasGas MC 450, you will need to loosen the screws that hold it to its housing: this piece will be …

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos