Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch on a Husaberg FE 450

Model: Husaberg Fe 450
Part: Clutch

Video tutorial

To replace the clutch on the Husaberg FE 450, loosen the screws securing the cover located on the lower centre of the right side of the bike. Once this cover is removed, you will locate the underlying clutch.

Extract the clutch from its housing by sliding out all the discs that comprise it. After removing the old clutch, insert the new one into its place, then cover everything with the cover. After installation, check that the vehicle is functioning properly.


Updated on 16 August 2026 by ScegliAuto


Related tutorials

How to replace the clutch on the Husaberg FE 450?
How to replace the clutch on the Husaberg FE 450?
Fe 450 To replace the clutch on the Husaberg FE 450, loosen the screws securing the cover located on the lower right side of the bike. Once the cover is rem…
How to Replace the Clutch on a Husaberg FE 450
How to Replace the Clutch on a Husaberg FE 450
Fe 450 To replace the clutch on a Husaberg FE 450, start by loosening the bolts that secure the clutch cover, located at the bottom of the right side of the…
How to Replace the Clutch on the Husaberg FE 450
How to Replace the Clutch on the Husaberg FE 450
Fe 450 In today's video, we will go through the steps to dismantle and replace the clutch discs on the Husaberg FE 450 enduro bike, following the instructio…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos