|
Do it yourself
| |||
| ||||
Model: Gasgas Ec 300
This guide provides the main instructions on how to remove and replace the radiator thermostat on the Gasgas EC 300 enduro bike. First, place your bike on a stand and disconnect the radiator hose, draining the fluid into a container for about ten minutes; then unscrew the thermostat screws to remove it from the radiator, as shown in the video. At this point, install the new original thermostat valve, securing it to the radiator, then pour in the new coolant and start the engine to circulate it!
Updated on 5 August 2026 by ScegliAuto
Video tutorial
Related tutorials
Ec 300
To replace the cylinder of the GasGas EC 300, you first need to disconnect the ignition coil connected at the top and then remove the spark plug that…
Ec 300
Today, you will learn how to remove and replace the carburettor on a Gasgas EC 300 enduro bike by following these simple steps. First, place your bik…
Ec 300
To replace the starter motor on the GasGas EC 300, detach the left side fairing of the bike, located near the bottom of the fuel tank. Once the panel…
|
How to Replace the Coolant in the Piaggio Medley 125?
To replace the coolant in the Piaggio Medley 125, loosen the screws securing the side grille of the scooter to remove it and access the radiator underneath. At the base of the radiator, locate the drain plug, which must be unscrewed to allow the coolant to flow into a suitably positioned container. Next, open the under-seat compartment and locate the coolant refill cap: by opening this cap, you can insert the new coolant. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |