Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Bmw R1200rt
Part: Engine oil

To change the motor oil of a BMW R1200T, follow these steps. Make sure the motorcycle is on a flat surface and that the engine is warm but not too hot. Remove the oil filler cap and the oil drain plug, which are usually located on the bottom side of the engine. Place a collection container under the drain plug and unscrew it to completely drain the used oil. Once drained, remove and replace the oil filter, making sure to clean the mounting surface thoroughly. Install the new filter and screw in the oil drain plug. Fill the engine with new oil through the filler cap until reaching the recommended quantity, checking the level with the oil dipstick if necessary. Securely close both caps. Start the engine for a few minutes to circulate the new oil, then turn it off, and the replacement is complete.

Posted on 6 December 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Position Bulb on a BMW R1200RT Motorcycle?
How to Change the Position Bulb on a BMW R1200RT Motorcycle?
R1200rt To change the position bulb on a BMW R1200RT motorcycle, first remove the side mirror, which is held in place by a clip mechanism. Next, remove the t…
How to Replace the Battery in the BMW R1200 RT?
How to Replace the Battery in the BMW R1200 RT?
R1200rt In this guide, you will find instructions on how to remove and replace the battery in the BMW R1200 RT motorcycle. First, place the bike on its stand…
Removing the Rear View Mirror of the BMW R1200 RT
Removing the Rear View Mirror of the BMW R1200 RT
R1200rt This guide shows you how to remove and replace the rear view mirror of the BMW R1200 RT motorbike in simple, quick steps. First, place the bike on a …

How do you replace the headlight bulb of the Kymco Downtown 300i?

In order to replace the headlight bulb of the Kymco Downtown 300i, it is necessary to loosen the screws that secure the panels located at the front of the vehicle fairing: once the fixing screws of these panels have been loosened, those on the inside of the front fairing can be unscrewed, so that the latter can be removed from its housing. Now it will be possible to proceed by unscrewing the screws that secure the corresponding headlight, disconnecting the connector and removing the bulb inside; in this way the fairings can be reinstalled.

Watch the video!


by ScegliAuto

More videos