Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the engine oil of a Yamaha MT-07?

Model: Yamaha Mt 07
Part: Engine oil

Video tutorial

To replace the engine oil of a Yamaha MT-07, follow these steps. Start by positioning the motorcycle on a flat surface and make sure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine crankcase, usually located on the lower side of the engine.

Place a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, screw the drain plug back in. Remove and replace the oil filter using an oil filter wrench. Apply some new oil on the gasket of the new filter before installation.

Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary.

Screw the oil cap back on and make sure it is tight. Start the engine and let it run for a few minutes to distribute the oil, and the procedure will be complete.


Posted on 6 December 2024 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on a Yamaha MT 07
How to Replace the Engine Oil and Oil Filter on a Yamaha MT 07
Mt 07 Replace the engine oil and oil filter as part of the routine maintenance service on your Yamaha MT 07 by following the instructions below. First, pla…
How to Change the Engine Oil and Oil Filter on the Yamaha MT-07
How to Change the Engine Oil and Oil Filter on the Yamaha MT-07
Mt 07 Today, we will discover the necessary instructions to carry out the routine maintenance service by changing the engine oil and oil filter on the Yama…
How to Change Engine Oil and Oil Filter on a Yamaha MT-07
How to Change Engine Oil and Oil Filter on a Yamaha MT-07
Mt 07 Let's go through the steps to change the engine oil and oil filter on the Yamaha MT-07, following the instructions below. First, unscrew and remove t…

How to Replace the Clutch on a Kymco Downtown 125?

To replace the clutch on the Kymco Downtown 125, loosen the screws that secure the cover located on the left side of the bike, near the rear wheel. Once the screws are loosened, remove the cover to access the components underneath: the clutch at the rear can be removed by unscrewing the fixing screws and sliding out all the discs that make it up. At this point, insert the new replacement part, reposition the drive belt, and cover everything with the cover.

Watch the video!


by ScegliAuto

More videos