Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
It will be possible to replace the battery of the Harley Davidson Fat Boy by removing the side panels located next to the motorcycle seat, so that the side fixing screws can be removed. Once these screws have been unscrewed, it will be possible to completely remove the seat from its position in order to locate the battery underneath it. The battery can now be freed from its housing by unscrewing the screws and disconnecting the connectors, so that the new piece can be inserted. After installation, the seat can be reattached.

Posted on 22 May 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch on the Harley Davidson Fat Boy?
How to Replace the Clutch on the Harley Davidson Fat Boy?
Fat Boy To replace the clutch on the Harley Davidson Fat Boy, loosen the screws securing the transmission cover on the left side of the bike, just below the …
How do you replace the battery of the Harley Davidson Fat Boy?
How do you replace the battery of the Harley Davidson Fat Boy?
Fat Boy To replace the battery of the Harley Davidson Fat Boy, you will need to detach the side panels located next to the motorcycle seat, so that the side …
How to Change the Engine Oil of the Harley Davidson Fat Boy?
How to Change the Engine Oil of the Harley Davidson Fat Boy?
Fat Boy To change the engine oil of the Harley Davidson Fat Boy, loosen the drain plug located at the bottom centre of the bike. Once the plug is loosened, c…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos