Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
These short and simple steps will show us how to disassemble and replace the spark plug of the engine of the Honda Elite 50 scooter. First, we put the scooter on the center stand and begin to lift the seat and remove the small plastic cover; on the inside, we then disconnect the spark plug connector, and then unscrew the spark plug with a socket wrench, as shown in the video. At this point, we install the new spark plug, screwing it in by hand and then gently tightening it with a wrench; we then reconnect the spark plug, finally starting the engine!

Posted on 15 September 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Transmission on a Honda Elite 50
How to Replace the Transmission on a Honda Elite 50
Elite 50 To replace the transmission on a Honda Elite 50, remove the screws securing the cover near the rear wheel on the left side of the bike. Once the scre…
How to Replace the Battery in a Honda Elite 50?
How to Replace the Battery in a Honda Elite 50?
Elite 50 To replace the battery in a Honda Elite 50, open the under-seat compartment using the appropriate key to access the screw located just below the seat…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos