Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video, you will see the steps to remove and replace the front headlight bulb on a Honda CBR 929 RR Fireblade. To access the bulb, it is not necessary to remove the front headlight or the fairings; you can access it from the back of the headlight with the limited space available. Disconnect the electrical connector of the bulb and remove the rubber protective cap; unclip the metal spring and extract the old bulb. Replace it with a new one of the correct type (in this case, H7); then reassemble everything!

Updated on 11 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Grips on the Honda CBR 929 RR
How to Replace the Grips on the Honda CBR 929 RR
Cbr 929 Watch this video to learn how to remove and replace the grips on the Honda CBR 929 RR Fireblade motorcycle, following the instructions below. First, …
How to Replace the Front Brake Pads on a Honda CBR 929 RR?
How to Replace the Front Brake Pads on a Honda CBR 929 RR?
Cbr 929 To replace the front brake pads on a Honda CBR 929 RR, loosen the bolts securing the brake caliper to the corresponding disc: after the caliper has b…
How to replace the brake pads on the Honda Cbr 929
How to replace the brake pads on the Honda Cbr 929
Cbr 929 Today, we will see how to remove and replace the front brake pads, which also applies to the rear ones, on the Honda Cbr 929 motorcycle. First, unscr…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos