Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, you will learn how to replace the headlamp bulb on a Honda Shadow, a very simple and quick operation. Before proceeding, ensure that the key is not in the ignition for safety. Start by positioning yourself in front of the headlamp, then locate and remove the bolt on the left side. Next, grasp the headlamp, pull it outwards, and separate it from the base. At this point, disconnect the power connector, remove the rubber cap, unclip the metal clip, and take out the bulb. To fit the replacement and reassemble everything, simply follow the reverse procedure.

Updated on 11 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Headlamp on a Honda Shadow
How to Replace the Headlamp on a Honda Shadow
Shadow 600 With the help of this video tutorial, you will learn how to replace the original headlamp and the corresponding bulb on the Honda Shadow VT 600 C wit…
How to Replace the Battery on the Honda Shadow 600?
How to Replace the Battery on the Honda Shadow 600?
Shadow 600 To replace the battery on the Honda Shadow 600, detach the cover of the casing located immediately under the seat, on the right side of the bike. Onc…
How to replace the battery in the Honda Shadow 600?
How to replace the battery in the Honda Shadow 600?
Shadow 600 To replace the battery on the Honda Shadow 600, detach the cover of the casing located immediately under the seat, on the right side of the bike. Onc…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos