Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Sh 125i
Part: Battery

This guide shows how to remove and replace the battery of the Honda SH 125 scooter, following the instructions below. First, place your scooter on the centre stand and begin by removing the plastic cover found on the footwell. Then, unscrew the bolts of the central bracket that secures the battery, as shown in the video. At this point, disconnect both battery terminals (positive and negative), remove and replace the battery with a new one; install the new battery of the correct type and with the same amperage!

Updated on 25 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the battery of the Honda SH 125?
How do you replace the battery of the Honda SH 125?
Sh 125i In order to replace the battery of the Honda SH 125, you will need to loosen the screws that hold the front panel of the motorcycle, just below the f…
How to Set the Time on Honda SH 125 Scooter?
How to Set the Time on Honda SH 125 Scooter?
Sh 125i In this tutorial, learn how to set the time on the Honda SH 125 scooter, a very simple and quick operation, for example, after switching to daylight …
How to change the transmission oil on the Honda SH 125 scooter
How to change the transmission oil on the Honda SH 125 scooter
Sh 125i In this tutorial, you can see how to change the engine oil on the Honda SH 125 scooter, a very simple and quick operation. First, wait for the engine…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos