Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today's instructions will show us how to disassemble and replace the rear headlight bulb of the Honda Click 125 scooter. First, we put the scooter on the center stand and start unscrewing the fixing screws found under the rear headlight; then we remove the rear headlight lights and replace them with new ones, having the same attachment, as shown in the video. At this point, we check the functioning of the stop lights before reassembling everything; we install the rear headlight, correctly fixing the screws found at the bottom, following the video tutorial until the end!

Posted on 15 August 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Oil Light on a Honda Click 125
How to Reset the Oil Light on a Honda Click 125
Click 125 In this mini guide for your Honda Click 125, we will discover how to manually reset the oil light. First, place your Honda Click 125 on its stand and…
How to Replace the Air Filter of a Honda Click 125
How to Replace the Air Filter of a Honda Click 125
Click 125 Start by placing your Honda Click 125 on its centre stand. Next, unscrew and remove the screws securing the air filter cover, then dislodge and remov…
How to Reset the Service on a Honda Click 125 Scooter?
How to Reset the Service on a Honda Click 125 Scooter?
Click 125 This tutorial shows how to reset the oil service on a Honda Click 125 scooter, a very simple and quick operation. Before proceeding, ensure you have …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos