Do it yourself
Frequently asked questions about cars and motorcycles

Honda Sw T - Videoguide

Honda Sw T
Disassembly of the transmission of the Honda SW T.

Today, in this video tutorial, we will see how to disassemble and replace the transmission of the Honda SW T scooter, in simple steps. First, we put our …read all…
Posted on 4 May 2023 by ScegliAuto
Honda Sw T
How to replace the headlight bulb on Honda SW-T 600?

In order to replace the Honda SW-T 600 headlight bulb, you need to access the inside of the front fairing, immediately under the steering wheel of the …read all…
Posted on 4 July 2022 by ScegliAuto
Honda Sw T
How to replace engine oil and oil filter on a Honda Sw

Today we are going to see how to change the engine oil on our Honda Sw, first we take a container to collect the used oil and put it under the oil drain plug, …read all…
Posted on 14 November 2023 by ScegliAuto
Honda Sw T
Replacing the air filter on Honda Sw T400

Let's see the replacement of the original engine air filter on a Honda Sw T400 scooter. Let's see in this video guide how to proceed with the replacement. We …read all…
Posted on 12 November 2023 by ScegliAuto
Honda Sw T
How to replace brake pads on a Honda sw-t

Today in this short video we are going to see how to replace the brake pads on our Honda sw-t, it is not a very complex operation, just have a little foresight …read all…
Posted on 12 November 2023 by ScegliAuto
Honda Sw T
How to remove the spark plug on a Honda sw-t

Today we are going to see how to go and replace the spark plug of our Honda sw-t, first of all we are going to remove the screws of the plastic placed in the …read all…
Posted on 10 November 2023 by ScegliAuto
Spark plugs (1) Air filter (1) Headlight bulb (1) Engine oil (1) Brake pads (1) Transmission (1)

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos