Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Sw T
Part: Air filter

Replace the original engine air filter on a Honda Sw T400 scooter. Follow this guide to proceed with the replacement. Position the scooter on the centre stand. Using a screwdriver, unscrew the securing screws of the right rear fairing; remove the right footrest (as shown in the video). After removing the screws from the housing, uncover the cap and remove the filter. Install the new filter (if damaged) or reposition the old one after cleaning it (use an air compressor). Finally, close the air filter housing and reassemble the fairing.

Updated on 9 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace Engine Oil and Oil Filter on a Honda SW
How to Replace Engine Oil and Oil Filter on a Honda SW
Sw T Today, you will see how to change the engine oil on your Honda SW. First, take a container to collect the used oil and place it under the oil drain p…
How to Remove the Spark Plug on a Honda SW-T
How to Remove the Spark Plug on a Honda SW-T
Sw T Today, you will learn how to replace the spark plug on your Honda SW-T. First, remove the screws from the plastic cover on the footwell of your scoot…
How to Replace the Front Headlight Bulb in a Honda SW-T 600?
How to Replace the Front Headlight Bulb in a Honda SW-T 600?
Sw T To replace the front headlight bulb in a Honda SW-T 600, access the inside of the front fairing, just below the handlebars of the motorcycle. Here, y…

How to Replace the Front Headlight on the Husqvarna 701?

In this tutorial, you will see how to replace the front headlight on the Husqvarna 701, a very simple and quick operation. First, ensure that the key is not inserted, then position yourself in front of the motorcycle, locate the four bolts on either side of the headlamp, and unscrew them using a Torx T30 key. Next, pull the entire assembly towards you, separate it from the support, and disconnect the power connector. At this point, you can separate the headlight from the panel, position the replacement, and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos