Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this short video, learn how to remove and replace the rear brake disc and sprocket on a Husqvarna Nuda 900 motorcycle. First, lift the rear of the motorcycle; then remove the central bolt to take off the rear wheel, loosening the chain as shown in the video. Next, unscrew the fixing bolts of the sprocket to remove it and replace it with the new one; the same applies to the brake disc, where you will unscrew the fixing screws. Finally, reassemble everything by applying the reverse procedure of disassembly!

Updated on 5 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch Discs on the Husqvarna Nuda 900
How to Replace the Clutch Discs on the Husqvarna Nuda 900
Nuda 900 In this video tutorial, we will see how to remove and replace the clutch discs on the Husqvarna Nuda 900, following the instructions below. First, re…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos