|
Do it yourself
| |||
| ||||
Replace the Coolant in the Husqvarna FE 350
Model: Husqvarna Fe 350
Video tutorial
Today, we will see in this brief and simple guide how to bleed and replace the coolant in the Husqvarna FE 350, following the instructions below. First, unscrew the coolant drain screw found on the water pump, allowing it to drain into a container; then unscrew the cap of the radiator and top up with the new coolant (the correct type for your radiator). At this point, start the engine to circulate the fluid; top up again if necessary!
Updated on 16 May 2026 by ScegliAuto
Related tutorials
Fe 350
To remove the rear mudguard of the Husqvarna FE 350, loosen the bolts securing the seat to its housing so that it can be completely removed. After re…
Fe 350
In this tutorial, you will see how to reset the service on the Husqvarna FE 350, a very simple and quick operation. Before proceeding, ensure you hav…
Fe 350
In this video, learn how to disassemble and replace the water pump seal on a Husqvarna FE 350 enduro bike, following the instructions below. First, d…
|
How to Replace the Front Brake Pads on the KTM SMT 990
To replace the front brake pads on the KTM SMT 990, you need to unscrew the screws that secure the pads within the corresponding caliper: once these screws are removed, you can slide the pads out of their housing inside the caliper. When the old pads are removed, you can insert the new replacement parts, securing them in their place with the corresponding pin. After the pads are correctly inserted and secured, check that everything functions properly. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
