Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil and Oil Filter Replacement for the Husqvarna FE 450

Model: Husqvarna Fe 450
Part: Engine oil

Video tutorial

Below are the instructions that will allow you to carry out the routine maintenance service by replacing the engine oil and oil filter on the Husqvarna FE 450 enduro bike. First, warm up the engine for a few minutes and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the two screws of the oil filter cover, removing and replacing the cartridge with the new one, as shown in the video.

At this point, unscrew the filler cap and top up the oil!


Updated on 22 May 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Brake Pads on the Husqvarna FE 450
How to Replace the Rear Brake Pads on the Husqvarna FE 450
Fe 450 Here are the steps to remove and replace the rear brake pads on the Husqvarna FE 450 enduro bike. First, place the bike on a stand and start by remov…
How to Replace the Exhaust on the Husqvarna FE 450
How to Replace the Exhaust on the Husqvarna FE 450
Fe 450 In this video, find the main instructions on how to remove and replace the exhaust on the Husqvarna FE 450 enduro bike. First, place your bike on a s…
Replacing the Rear Wheel Bearing on the Husqvarna FE 450
Replacing the Rear Wheel Bearing on the Husqvarna FE 450
Fe 450 This guide shows how to remove and replace the rear wheel bearing on the Husqvarna FE 450 enduro bike. First, place the bike on a stand and begin by …

How to Replace the Air Filter on a Honda SH 300i Scooter?

In this tutorial, you will see how to replace the air filter on a Honda SH 300i scooter, a very simple and quick operation. Before proceeding, ensure the engine is completely cold for safety. Start by unscrewing both the 6 screws around the perimeter of the airbox and the 3 bolts of the circular cover, then remove the cover and unscrew the additional screw that has just been freed. Next, separate the box, remove the old filter, and clean the housing of any dirt residue. Finally, follow the reverse procedure to install the replacement.

Watch the video!


by ScegliAuto

More videos