Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Here are the steps to remove and replace the rear brake pads on the Husqvarna FE 450 enduro bike. First, place the bike on a stand and start by removing the brake pad retaining pin using pliers; then extract the pads located inside the brake caliper, as shown in the video. At this point, clean the caliper of any residual dirt and insert the new brake pads in the correct orientation; securely fasten the pin to hold everything in place!

Updated on 20 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Exhaust on the Husqvarna FE 450
How to Replace the Exhaust on the Husqvarna FE 450
Fe 450 In this video, find the main instructions on how to remove and replace the exhaust on the Husqvarna FE 450 enduro bike. First, place your bike on a s…
Replacing the Rear Wheel Bearing on the Husqvarna FE 450
Replacing the Rear Wheel Bearing on the Husqvarna FE 450
Fe 450 This guide shows how to remove and replace the rear wheel bearing on the Husqvarna FE 450 enduro bike. First, place the bike on a stand and begin by …
How to perform service on the Husqvarna FE 450
How to perform service on the Husqvarna FE 450
Fe 450 In this brief and simple guide, discover the instructions for performing routine maintenance on the Husqvarna FE 450 by replacing the engine oil, air…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos