Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Husqvarna
    3. :
  3. Fe 350
    4. : How to replace the rear light and turn signals on the Husqvarna FE 350.

Model: Husqvarna Fe 350
Part: Tail light
How to replace the rear light and turn signals on the Husqvarna FE 350.

In this short and simple guide, we will see the steps that will allow us to disassemble and replace the rear light and turn signals of the Husqvarna FE 350 enduro motorcycle. First of all, we put our motorcycle on the stand and start by removing the seat; then we start unscrewing the fixing screws of the license plate holder and the rear light, disconnecting all the wiring of both the headlight and the turn signal bulbs; then we remove everything, as shown in the video. At this point, we install the new rear light and replace the turn signals, suitable for our license plate holder, following the video tutorial until the end!


Posted on 11 September 2023 by ScegliAuto



How do you replace the rear fender on the Husqvarna FE 350?
Fe 350 In order to remove the rear fender of the Husqvarna FE 350 you have to loosen the bolts that secure the saddle to its housing, so that it can be remo
Change the coolant of the Husqvarna FE 350
Fe 350 Today we will see, in this short and simple guide, how to bleed and replace the coolant of the Husqvarna FE 350, following the instructions below. Fi
How to reset the service in the Husqvarna FE 350?
Fe 350 In this tutorial we can see how to reset the service in the Husqvarna FE 350, an extremely simple and fast operation. Before proceeding, make sure yo

How to replace Kawasaki Z750 engine oil and oil filter

Today, in this guide, let's see the main steps that will allow us to carry out the routine maintenance service, replacing the engine oil and oil filter of the Kawasaki Z750 motorcycle. First of all we put our motorbike on the stand and we begin to unscrew the oil vent bolt that we find under the engine, letting it drain in a container for about ten minutes; after which we use the special wrench to unscrew and remove the oil filter, replacing the cartridge with the new one, as shown in the video. Finally we top up with the new engine oil!

Watch the video!


by ScegliAuto

More videos