Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To reset the Service light on the Husqvarna Norden 901, turn the ignition key to switch on the instrument panel. Once the panel is on, use the indicator buttons on the left side of the handlebars to navigate to the "Settings" option. Now, press the up and down arrow buttons simultaneously to select "Distance" on the screen that appears. You can then adjust the maintenance interval using the arrows, which will turn off the Service light.

Updated on 19 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the service light on the Husqvarna Norden 901
How to reset the service light on the Husqvarna Norden 901
Norden 901 Let's discover the procedure that will allow us to reset the service indicator light for the regular maintenance of the engine oil change on the Husq…
How do you reset the Service light on the Husqvarna Norden 901?
How do you reset the Service light on the Husqvarna Norden 901?
Norden 901 We discover about the Husqvarna Norden 901, how to reset the Service light, using the help of the video attached here. Like with cars and vehicles in…
How to reset the service on the Husqvarna Norden 901?
How to reset the service on the Husqvarna Norden 901?
Norden 901 In this tutorial, we can see how to reset the service on the Husqvarna Norden 901, an extremely simple and quick operation, to be performed only once…

Float Replacement on Piaggio X9

To replace the float on the Piaggio X9 250, you need to disassemble it completely. Start by removing the two bolts from the underseat compartment and disconnect the rear light connector. Inside, there are two more screws to remove, two side bolts, and two at the bottom of the bodywork. On the lower plastic where the exhaust is, there is another bolt to remove and another underneath. That piece slides back and can be removed by pulling it hard. Then, there are three large support bolts for the footrest and three smaller ones. Remove the three bolts from the carburettor airbox and disconnect it, including all the carburettor fuel hoses. Next, remove the bolt near the glove compartment to take off the handle. There will be two more small bolts. At this point, by removing the bolt under the headlight, you can also take off the left fairing. Finish by removing the three Allen screws on top. Disconnect the bulbs by removing the headlight cover. Slide the seat back by disconnecting the connector. Remove the three bolts from the cover. Remove the four screws holding the fuel cap (you must also remove the cap gasket, otherwise it won't come off). Remove the two bolts holding the rest of the footrest (as previously mentioned). This exposes the part you are interested in. Also, open the top by removing the underseat cover plastic. Loosen the throttle and deceleration cable. Remove the bolt securing the diaphragm, loosen the clamps on the manifolds, and disconnect the fuel and air hoses. Now the carburettor can be removed. All that remains is to unscrew the four bolts of the float and change the float chamber, which must not have any play but stay firmly in place. Now, all that is left is to reassemble everything in reverse order of disassembly!

Watch the video!


by ScegliAuto

More videos