Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Speaker on the Hyundai Elantra?

Model: Hyundai Elantra MK 6 - Years: 2015, 2016, 2017, 2018, 2019, 2020
Part: Speaker

See other generations:
Video tutorial

To replace the speaker on the Hyundai Elantra, remove the corresponding door panel: this can be done by detaching the protective cover of the retaining screw, located near the window switch. Once this screw is removed, detach the cover near the exterior mirror and then the entire door panel.

After removing the panel, unscrew the screws that secure the speaker and disconnect its connector: when the old speaker is freed, insert the new one, securing and connecting it properly.


Updated on 7 August 2026 by ScegliAuto


Related tutorials

How to Replace the Battery on a Hyundai Elantra?
How to Replace the Battery on a Hyundai Elantra?
Hyundai Elantra (2015-2020 / MK 6) To replace the battery on a Hyundai Elantra, open the bonnet to access the components located inside the engine bay: at the top right, just below the…
How to replace the front bumper on the Hyundai Elantra.
Hyundai Elantra (2015-2020 / MK 6) To replace the front bumper on the Hyundai Elantra, the steps are simple and are as follows. First, let's remove the four visible upper fasteners by …
How to Replace the Timing Belt on the Hyundai Elantra?
How to Replace the Timing Belt on the Hyundai Elantra?
Hyundai Elantra (2006-2010 / MK 4, HD) To replace the timing belt on the Hyundai Elantra, loosen the screws securing the cover on the left side of the engine block. Once this cover is remo…

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos