Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Turn Off the Check Engine Light on the Isuzu Mu X?

Model: Isuzu Mu X MK  1, RF - Years: 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020
Part: Warning light – error code

See other generations:
Video tutorial

In this video, we can see how to reset the check engine light on the Isuzu Mu X without using computerized equipment. This method is also valid for other car models, not necessarily similar to this one, but it may not work if you try to turn off the light without first resolving the issue.

Essentially, you need to open the hood, locate the battery, and disconnect the negative terminal for at least 30 seconds (two minutes is recommended). After that, once the battery is reconnected properly and the instrument panel is turned back on, the check engine light should be off.


Updated on 3 June 2026 by ScegliAuto


Related tutorials

How to Reset the Maintenance Light on Your Isuzu Mu X
How to Reset the Maintenance Light on Your Isuzu Mu X
Isuzu Mu X (2020-2026 / MK 2) In this guide, you will learn a very simple and effective method to reset the maintenance light on your Isuzu Mu X without using any diagnostic tools…
How to Replace the Air Filter on an Isuzu MU-X?
How to Replace the Air Filter on an Isuzu MU-X?
Isuzu Mu X (2013-2020 / MK  1, RF) To replace the air filter on an Isuzu MU-X, open the hood to access the components inside the engine compartment. On the left side, you will find the…
How to Replace the Cabin Filter of the Isuzu MU-X?
How to Replace the Cabin Filter of the Isuzu MU-X?
Isuzu Mu X (2020-2026 / MK 2) To replace the cabin filter of the Isuzu MU-X, open the glove compartment located on the passenger side: this will allow you to loosen the screws tha…

How to replace the handbrake button on the Opel Mokka?

The handbrake button on the Opel Mokka can be replaced without going to a mechanic. The installation system is snap-fit with plastic clips and does not require special tools. First, remove the old button, possibly using a flat screwdriver to pry it off. Next, check for any fragments and remove them using tweezers if necessary. At this point, install the new button by placing it in its seat and applying light pressure to snap the clips into place.

Watch the video!


by ScegliAuto

More videos