Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Cherokee
    4. : Low beam replacement on Jeep Cherokee

Jeep Cherokee - Video tutorial

Model: Jeep Cherokee MK 5, KL - Years 2013-2023
Part: Headlight bulb
Operation: Low beam replacement on Jeep Cherokee

Using an 8 mm socket wrench, unscrew the three screws that secure the front wheel arch. Then with a lever or a flat-head screwdriver detach it a little at a time until it is completely removed, as shown in the video. At this point you can see the seat of the dipped beam headlight: unscrew the rear cover by hand and then unscrew the connector that will come out of the seat together with the bulb. Take out the light bulb and that's it. Insert the new bulb and screw everything back on. As you can see, it is a rather simple operation although it must be accessed from below, and therefore from the wheel arch, rather than from the engine compartment.


Posted on 21 January 2024 by ScegliAuto



How to replace low beam bulbs in Jeep Cherokee?
Jeep Cherokee (2013-2023 / MK 5, KL) In this tutorial we can see how to replace the low beam bulbs in the Jeep Cherokee, a very simple and fast operation. First, let's make sure the key
How to replace the headlight bulb on the Jeep Cherokee 5
Jeep Cherokee (2013-2023 / MK 5, KL) Let's see in this short and simple guide how to remove and replace the low beam headlight bulb of the fifth generation Jeep Cherokee. First of all, l
Replacing the low beam bulb on Jeep Cherokee
Jeep Cherokee (2013-2023 / MK 5, KL) In this video we see how to replace the low beam bulb on 2014 Jeep Cherokee. Lifting the hood you will notice the rear cover of the headlight: this c

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos