Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Kawasaki Er 6n - Videoguide

Kawasaki Er 6n
How to replace the engine oil and oil filter of the Kawasaki ER-6N.
The procedure for replacing the engine oil and oil filter is really very simple and does not require the use of special tools; let's see how to perform …read all…
Posted on 30 November 2023 by ScegliAuto
Kawasaki Er 6n
How to change the engine oil and oil filter of Kawasaki ER-6N
Let's find out in this guide the steps on how to carry out the routine maintenance service, replacing the engine oil and the oil filter, of the Kawasaki ER-6N …read all…
Posted on 28 September 2022 by ScegliAuto
Kawasaki Er 6n
Replace the Kawasaki ER-6N air filter and spark plugs
In today's video we will see how to remove and replace the engine air filter and spark plugs of the Kawasaki ER-6N, in simple and quick steps. First of all we …read all…
Posted on 24 March 2024 by ScegliAuto
Kawasaki Er 6n
How to change the engine oil of a Kawasaki ER-6n
Before we can begin, we will have to place our Kawasaki ER-6n in an upright position, and then we will have to run the engine for a few minutes. Let's start by …read all…
Posted on 10 February 2024 by ScegliAuto
Kawasaki Er 6n
Kawasaki ER-6N chain maintenance
This small maintenance is recommended every 500, maximum 1000 km. Get yourself a brush, a container and the lubricant. Clean the chain with white petroleum …read all…
Posted on 23 December 2023 by ScegliAuto
(1) Air filter (1) Engine oil (3)

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos