Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
As clearly shown in the video, use a medium-sized flat screwdriver to widen the position of the pads relative to the central stop. Using an Allen key, unscrew the pin that holds the pads inside the caliper, and once the bolt is removed, take them out. Properly position the two new pads you purchased that fit the motorcycle's brake caliper, then insert the fixing pin by hand and finally tighten it with the Allen key. As you can see, this is a very simple operation that is within everyone's reach.

Updated on 16 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the engine oil and oil filter of the Kawasaki KX 450F
Replacement of the engine oil and oil filter of the Kawasaki KX 450F
Kx 450f Below we will see how to perform the regular maintenance service, replacing the engine oil and the oil filter, on the Kawasaki KX 450F enduro motorcy…
How to Change the Engine Oil on the Kawasaki KX 450F?
How to Change the Engine Oil on the Kawasaki KX 450F?
Kx 450f In this tutorial, you will learn how to change the engine oil on the Kawasaki KX 450F, a very simple and quick operation. First, wait until the engin…
How do you replace the rear shock absorber of the Kawasaki KX 450F?
How do you replace the rear shock absorber of the Kawasaki KX 450F?
Kx 450f In order to replace the rear shock absorber of the Kawasaki KX 450F, you need to loosen the screws that secure the side fairings of the bike, which a…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos