Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kawasaki Z800
Part: Brake pads

In today's tutorial video, you will learn how to remove and replace the front brake pads on the Kawasaki Z800 motorcycle in simple and quick steps. First, place your motorcycle on a stand and start unscrewing the mounting bolts of the front brake caliper to remove it from the disc; then unscrew the central pin of the caliper to extract the old pads, as shown in the video. At this point, press the caliper piston to retract it, cleaning off any dirt; then install the new pads, following the video until the end!

Updated on 29 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Brake Pads of the Kawasaki Z800
Z800 Here are the main instructions for removing and replacing the rear brake pads of the Kawasaki Z800 motorcycle, following these simple steps. First, p…
How to change the unit of measurement of the tachometer of the Kawasaki Z800
How to change the unit of measurement of the tachometer of the Kawasaki Z800
Z800 If you want to switch from MPH to KMH (and vice versa) as the unit of measurement on the speedometer of your Kawasaki Z800, simply follow the procedu…
Replacing the Spark Plugs on the Kawasaki Z800
Replacing the Spark Plugs on the Kawasaki Z800
Z800 Today, discover the main steps to remove and replace the engine spark plugs on the Kawasaki Z800 motorcycle, following the instructions below. First,…

Guide to replacing the starter motor of the Piaggio Vespa ET4 150

Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the scooter on the center stand and lift the seat; we remove the battery, disconnecting both terminals, and then remove the compartment under the seat, as shown in the video. At this point, we disconnect the intake hose to access the starter motor, unscrewing its fastening screws and disconnecting the wiring to remove it; all that's left is to replace it with the new original one, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos