Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today we will see the steps that will allow us to disassemble and replace the low beam and high beam bulb of the front headlight of the KTM 1190 Adventure motorcycle. First, we put the motorcycle on the stand and start disassembling and removing the front headlight; to do this, we unscrew the screws of the side fairings to access the screws of the headlight assembly, disconnecting the electrical connector of the bulbs to remove it, as shown in the video. At this point, we remove the bulb and replace it with the new one, of the correct type and with the same attachment; finally, we reassemble the headlight assembly, adjusting the height of the light beam if necessary.

Posted on 2 March 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the rear turn signal bulb of the KTM 1190 Adventure?
How do you replace the rear turn signal bulb of the KTM 1190 Adventure?
1190 Adventure In order to replace the rear turn signal bulb of the KTM 1190 Adventure, you need to loosen the screw located on the left side of the corresponding r…
How do you replace the rear shock absorber of the KTM 1190 Adventure R?
How do you replace the rear shock absorber of the KTM 1190 Adventure R?
1190 Adventure In order to replace the rear shock absorber of the KTM 1190 Adventure R, you need to loosen the screws that fix it to its housing: this piece will be…
How do you replace the clutch of the KTM 1190 Adventure?
How do you replace the clutch of the KTM 1190 Adventure?
1190 Adventure In order to replace the clutch of the KTM 1190 Adventure, you need to loosen the screws that secure the clutch cover panel, located on the right side…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos