Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the license plate light of the KTM Duke 390

Model: Ktm Duke 390
Part: License plate light

Video tutorial

Today we will discover the instructions that will allow us to disassemble and replace the license plate light of the KTM Duke 390 motorcycle. First, put the motorcycle on the stand and start by removing the plastic cover of the license plate light, levering on the sides; then remove the bulb inside, replacing the entire bulb holder if necessary (disconnecting the electrical connector in this case), as shown in the video.

At this point, install the new license plate bulb, of the correct type and with the same attachment; all that's left is to verify its correct operation!


Posted on 28 September 2025 by ScegliAuto


Related tutorials

How to Reset the "Service" Light on a KTM Duke 390
How to Reset the "Service" Light on a KTM Duke 390
Duke 390 Before starting, the regular service should already have been performed, and then you need to sit on the rider's seat of your KTM Duke 390. Start by …
How to Reset the Service Light on the KTM Duke 390
How to Reset the Service Light on the KTM Duke 390
Duke 390 In this guide, follow the instructions to reset the maintenance light for the engine oil change on the KTM Duke 390. First, place the bike on a stand…
How do you replace the motor oil of the KTM Duke 390?
How do you replace the motor oil of the KTM Duke 390?
Duke 390 To perform the oil change on the KTM Duke 390, you will need to loosen the drain plug of the oil pan located in the central lower part of the vehicle…

How to replace the headlight bulb in the Triumph Tiger 800?

Replacing the headlight bulb in the Triumph Tiger 800, as shown in this tutorial, is an extremely simple and quick operation. First, ensure that the key is not inserted for safety, then locate the large cap on the back of the headlamp and unscrew it. Next, disconnect the power connector by pulling it outwards, unclip the metal clip, and remove the old bulb from the housing. At this point, insert the replacement, avoiding direct contact with the glass, and follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos