Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Insert the key into the designated slot under the rear seat and turn it to remove the seat itself, then remove the main rider's seat. Move the first battery cover, the one with the various connectors attached. Now, move to the actual battery protection: to remove it, unscrew the right T30 Torx screw, then unscrew and disconnect the positive terminal and remove the cover by extracting its attachments from the slots, as shown in the video. After this, unscrew the negative terminal with the T30 key, and you can finally extract the battery. Good luck!

Updated on 9 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery of the KTM Super Duke 1290?
How to Replace the Battery of the KTM Super Duke 1290?
Super Duke 1290 R To replace the battery of the KTM Super Duke 1290, loosen the bolts securing the seat to its housing. Once these bolts are loosened, lift the seat to…
How to Reset the Service Light on a KTM Super Duke 1290 R
How to Reset the Service Light on a KTM Super Duke 1290 R
Super Duke 1290 R This tutorial shows how to reset the service light on a KTM Super Duke 1290 R, a very simple and quick operation. Before proceeding, ensure that you …
How to Replace the Battery on a KTM Super Duke 1290 R?
How to Replace the Battery on a KTM Super Duke 1290 R?
Super Duke 1290 R To replace the battery on a KTM Super Duke 1290 R, loosen the screws that secure the seat, located on the right and left sides. Once all screws are l…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos