|
Do it yourself
| |||
| ||||
Model: Ktm Rc 390
In this brief and simple guide, learn how to remove and replace the brake and clutch levers on the KTM RC 390 motorcycle. First, remove the clutch lever; take off the rubber cover and unscrew the lever pivot bolt, then disconnect the clutch cable as shown in the video. Next, fit the new lever of the correct type. Similarly, remove and replace the front brake lever, and finally adjust the braking, following the video to the end!
Updated on 17 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Rc 390
To replace the front brake pads on a KTM RC 390, loosen the bolts securing the brake caliper to its housing on the disc: once the bolts are loosened,…
Rc 390
It will be possible to replace the front brake pads of the KTM RC 390 by loosening the screws that secure the brake caliper corresponding to the disc…
Rc 390
Before starting, it is advisable to position your KTM RC 390 upright. Begin by unscrewing and removing the internal and external screws that secure t…
|
How to Replace the Engine Cover on a Honda CB 650R
This guide provides instructions for removing and replacing the engine cover on a Honda CB 650R motorcycle, following these simple steps. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. Then, unscrew all the screws from the cover or engine casing found on the right, as shown in the video. At this point, install the new cover, ensuring to replace the gasket and clean the base thoroughly. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.458
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
