Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the front wheel of the Kymco Agility

Model: Kymco Agility 50
Part: Wheel

Video tutorial

Today we will explain how to remove the front wheel of the Kymco Agility 50 scooter. To perform this operation, we must first lift the scooter and immediately after, using the brake caliper, remove the bolts with a 12mm wrench.

Once the brake caliper is removed, we can lift the tube. This operation is necessary to avoid damaging the tube, as the weight of the free brake caliper could damage it. Remove the nut with a 14mm wrench on one side and a 19mm wrench on the other, and finally remove the front wheel.

The assembly follows the same procedure in reverse.


Posted on 4 September 2025 by ScegliAuto


Related tutorials

How to change the oil of the Kymco Agility 50
How to change the oil of the Kymco Agility 50
Agility 50 In the following mini guide, we will discover together how to correctly change the oil of your Kymco Agility 50. First of all, make sure you have the…
How to Replace the Air Filter of the Kymco Agility 50?
How to Replace the Air Filter of the Kymco Agility 50?
Agility 50 To replace the air filter of the Kymco Agility 50, loosen the screws securing the air filter box: this is located near the rear wheel on the left sid…
How to change the headlight bulb of the Kymco Agility 50
Agility 50 Let's see the step-by-step instructions that will allow us to disassemble and replace the low beam and high beam bulb of the front headlight of the K…

How to Change the Engine Oil of a BMW R9T

To change the engine oil of a BMW R9T, follow these steps. Ensure the engine is warm but not too hot. Position the bike on a flat surface and lift the front using a motorcycle stand. Remove the oil cap from the engine oil reservoir. Place a catch container under the oil drain plug, usually located on the underside of the engine. Unscrew the oil drain plug and let the old oil drain completely into the container. Once drained, re-tighten the oil drain plug. Remove the oil filter using an oil filter wrench. Clean the mounting surface of the filter and apply a bit of new oil to the seal of the new filter. Install the new oil filter. At this point, fill the engine with new oil, and you will have completed the replacement.

Watch the video!


by ScegliAuto

More videos