Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you adjust the front headlight of the Kymco Downtown 300i?

Model: Kymco Downtown 300i
Part: Headlight

Video tutorial

To adjust the front headlight of the Kymco Downtown 300i, you need to completely remove the headlight assembly from its housing. To do this, you will need to detach the covering panels of the front fairing.

The underlying screws can be loosened so that the headlight can be extracted. Inside, you will find a screw: by tightening this screw, you will notice that the beam of light will be raised, while loosening it will lower the beam.

Finally, you can reinsert the headlight into its position, securing it with the appropriate screws.


Posted on 8 January 2026 by ScegliAuto


Related tutorials

How to Reset the "Service" Light on a Kymco Downtown 300i?
How to Reset the "Service" Light on a Kymco Downtown 300i?
Downtown 300i First, sit on the seat of your Kymco Downtown 300i. Start by activating the instrument panel by turning the key in the ignition switch. Next, press a…
How to Replace the Headlight Bulb on the Kymco Downtown 300i
How to Replace the Headlight Bulb on the Kymco Downtown 300i
Downtown 300i To replace the headlight bulb on the Kymco Downtown 300i, you need to loosen the screws that secure the panels located at the front of the vehicle's …
How to Replace the Headlight Bulb on a Kymco Downtown 300i
How to Replace the Headlight Bulb on a Kymco Downtown 300i
Downtown 300i Here are the instructions to remove and replace the headlight bulb on the Kymco Downtown 300i scooter. First, place your scooter on the centre stand …

Replacing the Rear Brake Pads of the BMW G310 GS

Follow these brief instructions to remove and replace the rear brake pads (this also applies to the front ones) of the BMW G310 GS motorcycle. First, place the bike on a stand and start by removing the pin and the clip from the rear brake caliper; then remove the old brake pads as shown in the video. Next, clean the caliper of any residual dirt, install the new original brake pads, and secure the pin and clip to lock everything in place, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos