Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the "Service" Light on a Kymco Xciting 300

Model: Kymco Xciting 300
Part: Service warning light

Video tutorial

Before starting, sit on the rider's seat of your Kymco Xciting 300. Begin by activating the instrument panel by turning the key in the ignition switch. Next, press and hold the button located at the bottom left of the multifunction display.

Hold the button until the "Service" light turns off. Once the "Service" light goes out, you can release the button. After completing this step, you will have successfully reset the light.


Updated on 19 April 2026 by ScegliAuto


Related tutorials

How to Replace the Exhaust on a Kymco Xciting 300?
How to Replace the Exhaust on a Kymco Xciting 300?
Xciting 300 To replace the exhaust on a Kymco Xciting 300, loosen the screws that secure it to the mounting near the rear wheel on the right side. Once the screw…
How do you replace the transmission of the Kymco Xciting 300?
How do you replace the transmission of the Kymco Xciting 300?
Xciting 300 The transmission of the Kymco Xciting 300 can be replaced by loosening the screws that secure the transmission housing, located on the left side of t…
How to Replace the Voltage Regulator on a Kymco Xciting 300?
How to Replace the Voltage Regulator on a Kymco Xciting 300?
Xciting 300 To replace the voltage regulator on a Kymco Xciting 300, remove all the screws securing the seat and lift it. The battery will be accessible, which m…

Replacing the Rear Brake Pads of the BMW G310 GS

Follow these brief instructions to remove and replace the rear brake pads (this also applies to the front ones) of the BMW G310 GS motorcycle. First, place the bike on a stand and start by removing the pin and the clip from the rear brake caliper; then remove the old brake pads as shown in the video. Next, clean the caliper of any residual dirt, install the new original brake pads, and secure the pin and clip to lock everything in place, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos