Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kymco Downtown 300i
Part: Pump

This guide outlines the main steps to remove and replace the coolant pump on the Kymco Downtown 300i scooter. First, place the central stand and start by disconnecting the coolant hose to drain the fluid into a container. Then, unscrew the screws of the water pump cover to remove it. At this point, replace the impeller or the pump, and reassemble everything, following the video tutorial to the end!

Updated on 10 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Water Pump on the Kymco Downtown 300i?
How to Replace the Water Pump on the Kymco Downtown 300i?
Downtown 300i To replace the water pump on the Kymco Downtown 300i, access the housing located on the right side of the bike, near the beginning of the exhaust. Op…
How to Reset the "Service" Light on a Kymco Downtown 300i?
How to Reset the "Service" Light on a Kymco Downtown 300i?
Downtown 300i First, sit on the seat of your Kymco Downtown 300i. Start by activating the instrument panel by turning the key in the ignition switch. Next, press a…
How to Replace the Engine Oil of the Kymco Downtown 300i
How to Replace the Engine Oil of the Kymco Downtown 300i
Downtown 300i Discover the procedure for replacing the engine oil while performing the routine maintenance service on the Kymco Downtown 300i scooter. First, place…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos