Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Adjust the Valves on the Malaguti Dune 125?

Model: Malaguti Dune 125
Part: Valve

Video tutorial

To adjust the valves on the Malaguti Dune 125, you must first remove the seat and the fuel tank by loosening the appropriate bolts. Once these two parts are removed, you will have access to the underlying components: open the top cover of the casing where the valves are located.

You can check the valves by inserting a feeler gauge into them. If the valve is too loose, tighten it; conversely, if it is too tight, loosen it. After checking the valves, close the casing again and reinstall all previously removed parts.


Updated on 20 May 2026 by ScegliAuto


Related tutorials

How to Adjust the Valves on a Malaguti Dune 125?
How to Adjust the Valves on a Malaguti Dune 125?
Dune 125 You can replace the valves on a Malaguti Dune 125 by loosening the screws that secure the seat from its housing, allowing you to detach it and access…
Engine Oil Change on Malaguti Dune 125 - Derbi Terra 125
Engine Oil Change on Malaguti Dune 125 - Derbi Terra 125
Dune 125 In this video, you will find the main instructions for performing an engine oil change during the regular maintenance service on a Malaguti Dune 125,…
How do you replace the spark plug of the Malaguti Dune 125?
How do you replace the spark plug of the Malaguti Dune 125?
Dune 125 The spark plug of the Malaguti Dune 125 can be replaced by disconnecting the corresponding ignition coil located on the top of the engine cylinder: o…

How to Clean the Throttle Body on a Piaggio Beverly

In today's video, see how to clean the throttle body on a Piaggio Beverly. This operation applies to all models of the Beverly from 125 to 500 over various years. First, remember to work only with a cold engine to avoid unpleasant burns. Next, remove the seat by unscrewing the appropriate fastening clips. Once done, proceed to remove the scooter's body; find and remove the appropriate fastening clips. At this point, you can carry out the work in question and then reassemble everything as it was.

Watch the video!


by ScegliAuto

More videos