Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the battery on Mazda 6

Model: Mazda 6 GJ, MK 3 - Years 2012-2024
Part: Battery

If the battery in our car is no longer efficient, your charge has been significantly reduced, we must replace it. In the description below we will find the instructions and steps to carry out. After opening the bonnet we will find the battery on the left side, we will therefore proceed first to connect the negative pole and then the positive one and then with the help of a spanner, let the fixing data of the steel crosspiece placed above the battery. In this way the battery will be free and then it can be extracted to then replace it with the new one and then proceed to reconnect first the positive pole and then the negative one and finally screw the fixing nuts of the upper crosspiece back on.

Posted on 5 July 2022 by ScegliAuto

Video tutorial

Related tutorials

How to replace the remote control battery on the Mazda 6 MK3
How to replace the remote control battery on the Mazda 6 MK3
Mazda 6 (2012-2024 / GJ, MK 3) Let's find out in this short guide how to remove and replace the remote control battery of the electronic key on the Mazda 6 third series, following …
…
How to replace mazda 6 key battery
How to replace mazda 6 key battery
Mazda 6 (2012-2024 / GJ, MK 3) In the following guide dedicated to all of you owners of a Mazda 6 (year 2012-2020) we will find out how to correctly replace the battery inside the …

How to Replace the Cabin Fan Resistor on a BMW 3 Series

How to Replace the Cabin Fan Resistor on a BMW 3 Series. Open the door and remove the plastic cover under the dashboard on the right side. Use a trim tool to pry off the cover next to the dashboard. Get a screwdriver or a cordless drill, open the glove compartment, and unscrew the fastening screws around the perimeter with a screwdriver. Once this is done, pull out the glove compartment and disconnect the power cables. Remove the fan resistor from its housing, insert the new part into the filter holder, and reassemble all the components of the glove compartment as you disassembled them earlier.

Watch the video!


by ScegliAuto

More videos