Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you reset the service light on the 2013 Mini Countryman?

Model: Mini Mini Various
Part: Service warning light

How do you reset the service light on the 2013 Mini Countryman? In order to reset the service warning light on our 2013 Mini Countryman it is necessary, first of all, to access the on-board computer menu. Once inside the menu, go to the maintenance section, and look for the appropriate reset item. At this point the on-board computer will perform a small processing which may last a few seconds, after which the service light will be reset. To check that the procedure has been carried out correctly, turn off the instrument panel and turn it on again: we will notice that the service warning light will now be off.

Posted on 4 October 2021 by ScegliAuto

Video tutorial

Related tutorials

How to remove the rear light of the 2017 Mini Countryman SE
How to remove the rear light of the 2017 Mini Countryman SE
Mini Mini Various The guide shows how to remove the rear light of the 2017 Mini Countryman SE. The first operation consists in opening the boot and removing the rubber…
How to replace the car radio in the Mini Countryman
How to replace the car radio in the Mini Countryman
Mini Mini Various In today's video we see how to remove the car radio in the first series Mini Countryman. This tutorial also applies to the other contemporary models …
Replacement of the Mini key battery
Replacement of the Mini key battery
Mini Mini Various Thanks to this very useful tutorial, we can see how to replace the battery (CR2025) of the keyless key of a MINI vehicle (Clubman, Countryman, Pacema…

How to Replace the Cabin Fan Resistor on a BMW 3 Series

How to Replace the Cabin Fan Resistor on a BMW 3 Series. Open the door and remove the plastic cover under the dashboard on the right side. Use a trim tool to pry off the cover next to the dashboard. Get a screwdriver or a cordless drill, open the glove compartment, and unscrew the fastening screws around the perimeter with a screwdriver. Once this is done, pull out the glove compartment and disconnect the power cables. Remove the fan resistor from its housing, insert the new part into the filter holder, and reassemble all the components of the glove compartment as you disassembled them earlier.

Watch the video!


by ScegliAuto

More videos