Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this brief guide, we will see how to maintain the hub and bearing of the rear wheel on the MV Agusta Turismo Veloce 800 motorcycle. First, place the motorcycle on the centre stand and begin removing the rear wheel by unscrewing the central nut and removing the lock; disconnect the brake caliper from the disc, as shown in the video. At this point, unscrew the screws of the rear hub to remove it; replace it if damaged, lubricating the components properly and checking the wear condition of the bearing, finally reassembling the wheel.

Posted on 1 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Sprocket Cover of the MV Agusta Turismo Veloce 800
How to Remove the Sprocket Cover of the MV Agusta Turismo Veloce 800
Turismo Veloce In this tutorial, you will learn how to remove the side cover of the sprocket to access the transmission chain or the sprocket itself of the MV Agust…
How do you replace the motor oil of the MV Agusta Turismo Veloce 800?
How do you replace the motor oil of the MV Agusta Turismo Veloce 800?
Turismo Veloce It will be possible to replace the MV Agusta Turismo Veloce 800 by loosening the oil drain plug located in the central lower part of the vehicle: onc…
How to Remove and Refit the Passenger and Rider Seat of the MV Agusta Turismo Veloce 800
How to Remove and Refit the Passenger and Rider Seat of the MV Agusta Turismo Veloce 800
Turismo Veloce In this brief and simple guide, we will see how to remove and refit the passenger and rider seat of the MV Agusta Turismo Veloce 800. First, place yo…

Guide to replacing the starter motor of the Piaggio Vespa ET4 150

Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the scooter on the center stand and lift the seat; we remove the battery, disconnecting both terminals, and then remove the compartment under the seat, as shown in the video. At this point, we disconnect the intake hose to access the starter motor, unscrewing its fastening screws and disconnecting the wiring to remove it; all that's left is to replace it with the new original one, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos