Do it yourself
Frequently asked questions about cars and motorcycles
Start the engine and let it run for several minutes before changing the oil: this will warm up the circulating lubricant and facilitate its subsequent drainage. Unscrew the 10 mm bolt located under the engine compartment using an Allen key, after preparing a container to collect the oil. While this is happening, unscrew the oil filter and only screw in the new one after lubricating the new O-ring (used oil is fine, the important thing is that it is lubricated). Measure the amount of oil that has drained and add the same amount of new 10W-60 oil. The oil filter is an H554.

Updated on 6 April 2026 by ScegliAuto

Video tutorial

Related tutorials

F4 750 To change the oil of the MV Agusta F4 750, you need to unscrew the drain plug located under the oil sump on the lower left side of the bike. Position…
F4 750 To change the engine oil of the MV Agusta F4 750, you need to unscrew the screws fixing the side and lower panels of the bike, particularly the one o…
F4 750 In order to replace the air filter of the MV Agusta F4 750, you need to completely remove the seat from its housing, so that you can access the compo…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos