Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video tutorial, follow the instructions to dismantle the components of the instrument cluster of the Mv Agusta Brutale 1078 RR in simple steps. First, remove the instrument cluster from your motorcycle by disconnecting the electrical connector located at the rear; then, unscrew the screws found behind the cluster using a cross-head screwdriver, as shown in the video. At this point, remove the electronic board of the cluster and, if necessary, replace the bulbs; follow the video to the end for complete dismantling!

Updated on 8 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Dismantling the front forks of the MV Agusta Brutale 1078 RR
Dismantling the front forks of the MV Agusta Brutale 1078 RR
Brutale 1078 Rr In this video tutorial, you will learn how to dismantle and service the front forks of the MV Agusta Brutale 1078 RR, following the instructions prov…
Removing the Rear Wheel Hub on a MV Agusta Brutale 1078 RR
Removing the Rear Wheel Hub on a MV Agusta Brutale 1078 RR
Brutale 1078 Rr In this video tutorial, you will learn how to remove and replace the rear wheel hub bearing on the MV Agusta Brutale 1078 RR motorcycle. First, remov…
How to Remove the Gear Selector Cover of the Mv Agusta Brutale 1078 RR
How to Remove the Gear Selector Cover of the Mv Agusta Brutale 1078 RR
Brutale 1078 Rr This brief and simple guide shows how to remove the gear selector cover of the Mv Agusta Brutale 1078 RR. First, drain the engine oil by unscrewing t…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos