Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the levers on a MV Agusta Brutale 1078RR, you need to loosen the nuts that secure the pins at the end of each lever: once these two nuts are loosened, you can remove the central pin of the lever and loosen the washer at its base. This will allow both the brake cable and the clutch cable to be disconnected from the corresponding lever; doing so will enable you to connect the appropriate cable to the corresponding lever, allowing you to secure the lever with the pin and the appropriate nut.

Updated on 21 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake Pads on a MV Agusta Brutale 1078RR?
How to Replace the Brake Pads on a MV Agusta Brutale 1078RR?
Brutale 1078 Rr To replace the brake pads on a MV Agusta Brutale 1078RR, unscrew the bolts securing the brake caliper to the corresponding disc so that it can be com…
How to Install the Fuel Pump on the MV Agusta Brutale 1078RR
How to Install the Fuel Pump on the MV Agusta Brutale 1078RR
Brutale 1078 Rr In this video tutorial, we will guide you through the installation of the new fuel pump on the tank of the MV Agusta Brutale 1078RR. Before installin…
How to Adjust the Valves on a MV Agusta Brutale 1078RR
How to Adjust the Valves on a MV Agusta Brutale 1078RR
Brutale 1078 Rr To check the valves on the MV Agusta Brutale 1078RR, you need to completely remove the engine block from its housing so that you can detach the corre…

How to Replace the Front Headlight on the BMW F800GS

In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector.

Watch the video!


by ScegliAuto

More videos