Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Mvagusta Brutale 800
Part:

To replace the chain on the MV Agusta Brutale 800, you need to break it at one point using a chain breaker. Once the chain is broken, you can loosen the nuts that secure the sprocket and the rear sprocket. When these nuts are loosened, you can slide the chain off the respective sprockets and position the new replacement part. At this point, rotate the sprockets so that the two ends of the new chain align; then you can join them by reinserting the pin.

Updated on 29 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Exhaust on a MV Agusta Brutale 800
How to Replace the Exhaust on a MV Agusta Brutale 800
Brutale 800 To replace the exhaust on the MV Agusta Brutale 800, you need to remove the plastic cover located on the right side of the bike, just before the exha…
How to Replace the Front Bulb on an MV Agusta Brutale 800
How to Replace the Front Bulb on an MV Agusta Brutale 800
Brutale 800 In today's video, learn how to install a new LED front light on the MV Agusta Brutale 800. First, ensure the engine is cold to avoid burns. Next, rem…
How do you replace the exhaust pipe of the MV Agusta Brutale 800?
How do you replace the exhaust pipe of the MV Agusta Brutale 800?
Brutale 800 The exhaust of the MV Agusta Brutale 800 can be replaced by removing the plastic panel located on the right side of the motorcycle, in the area immed…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos