Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Rogue
    4. : How to replace the Nissan Rogue reverse light bulb

Nissan Rogue - Video tutorial

Model: Nissan Rogue S35 - Years 2008-2015
Part: Rear light bulb
Operation: How to replace the Nissan Rogue reverse light bulb

In this guide today we will find out how to replace the reversing light bulb of the Nissan Rogue. We already tell you that it is a rather simple operation to perform so that you can do it in total autonomy without any kind of problem. Just follow our instructions and have a little patience. First lift the rear hood completely and locate the two upper screws holding the headlight in question. Unscrew them using a 10 mm wrench and immediately remove the small plastic cover located underneath. Unscrew the last screw inside the compartment and proceed with the removal of the entire headlight. Disconnect the connector and replace the old bulb with the new one. Finally, reassemble everything correctly and retighten the screws.


Posted on 6 April 2024 by ScegliAuto



How do you replace the license plate light bulb on your Nissan Rogue?
Nissan Rogue (2014-2020 / T32) In order to replace the light bulb on the Nissan Rogue license plate, you need to pry with an object so that you can extract the ceiling light locate
How do you replace the rear light bulb on a Nissan Rogue?
Nissan Rogue (2014-2020 / T32) Replacing the rear light bulb on the Nissan Rogue is done by opening the tailgate, so that you can locate the screws that secure the light unit to it
How to replace the rear light bulb on the Nissan Rogue?
Nissan Rogue (2008-2015 / S35) In order to replace the rear light bulb of the Nissan Rogue you have to go to open the trunk lid, so that the bolts next to the headlight can be unsc

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos