Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Headlamp Bulbs on Peugeot 207

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Tail light

Replace the damaged bulbs inside the rear headlamp of your Peugeot 207. Open the boot and remove the side trim panel. Locate the screws securing the rear headlamp. Unscrew all the screws holding the headlamp (matching sizes and voltage). Use a lever to detach the headlamp from its housing and disconnect the power connectors. After replacing the headlamp bulbs, refit the headlamp into the car's bodywork. Finally, test the correct operation of the bulbs you have installed in the 207's headlamp.

Updated on 10 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Headlamp Bulbs on a Peugeot 207
Replacing the Front Headlamp Bulbs on a Peugeot 207
Peugeot 207 (2006-2015 / MK 1) Replacing the front headlamp bulbs on a Peugeot 207. Open the front bonnet by pulling the lever located at the bottom right of the dashboard and secu…
How to Change the Front Headlamp Bulb of a Peugeot 207
How to Change the Front Headlamp Bulb of a Peugeot 207
Peugeot 207 (2006-2015 / MK 1) Learn how to change the front headlamp bulb of a Peugeot 207. Open the front bonnet by pulling the lever located at the bottom right of the dashboard…
Replacing the Rear Lights on a Peugeot 207
Replacing the Rear Lights on a Peugeot 207
Peugeot 207 (2006-2015 / MK 1) In this video tutorial, you will learn how to remove and replace the bulbs in the rear light of a Peugeot 207. First, open the boot and remove the pl…

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos