Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : Replacing the diesel filter on Peugeot 207 1.6 HDi

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Diesel filter
Operation: Replacing the diesel filter on Peugeot 207 1.6 HDi

In this video tutorial we are going to find out how to replace the diesel filter on a Peugeot 207 with 1.6 HDi engine. Let's start by opening the bonnet, remove the panel covering the filter, now detach the three pipes and the plug attached to the diesel filter by pushing the tabs down and pulling them out. Having done this, with an 8mm wrench, unscrew the two screws that hold the filter in place and remove it. Now let's separate the old filter from its housing by unscrewing three T15 torx screws and then mount the new filter. We reassemble everything in the engine compartment by performing the procedure in reverse, but before starting the vehicle we go to press the button above the filter as shown in the video which acts as a pump to let diesel fuel into the new filter.


Posted on 11 October 2022 by ScegliAuto

    Frequently Asked Questions

    • 207 2006-2015 - Where is the fuel filter of the Peugeot 207 located? Read Answer
    • 207 2006-2015 - Where is the fuel filter on Peugeot 207? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos