Do it yourself
Frequently asked questions about cars and motorcycles
The following steps will show us how to disassemble and replace the spark plug of the Piaggio Vespa 150 ET4 scooter engine. First of all, we put the scooter on the central stand and start by opening the seat and removing the compartment under the seat; we then disconnect the spark plug connector and use a socket wrench with extension to unscrew and remove it, as shown in the video. At this point, we install the new spark plug, of the right type, screwing it in by hand and then tightening it with a wrench; we connect the spark plug and check the correct ignition of the engine!

Posted on 13 June 2025 by ScegliAuto

Video tutorial

Related tutorials

Vespa Et4 To replace the spark plug on the Vespa ET4 125, first open the seat and remove the helmet compartment under the seat to access the engine. Locate the…
Vespa Et4 Today's instructions will guide you through removing and replacing the spark plug on the Piaggio Vespa ET4 125 scooter in simple steps. First, place …
Vespa Et4 Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the …

How to Replace the Engine Oil and Oil Filter on an Aprilia RSV 1000

This short video will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia RSV 1000 motorcycle. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then use the appropriate tool to unscrew and remove the oil filter, replacing the cartridge with a new one as shown in the video. Finally, unscrew the filler screw and top up by pouring in the suitable oil for your engine!

Watch the video!


by ScegliAuto

More videos