Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil and Oil Filter Replacement for the Piaggio MP3 300

Model: Piaggio Mp3 300
Part: Engine oil

Video tutorial

Today’s guide will show you how to perform routine maintenance by replacing the engine oil and oil filter on the Piaggio MP3 300 scooter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt located underneath, allowing the oil to drain into a container for about ten minutes; then unscrew the oil filter cartridge, removing it and replacing it with a new one, as shown in the video.

At this point, unscrew the filler cap and top up with new engine oil, checking the correct oil level afterwards.


Posted on 16 September 2026 by ScegliAuto


Related tutorials

How to reset the service light on the Piaggio MP3 300
How to reset the service light on the Piaggio MP3 300
Mp3 300 Let's find out how to reset the maintenance service light for the regular oil change of the Piaggio MP3 300 scooter. First of all, put the scooter on…
How to set the clock on the Piaggio MP3 300 HPE
How to set the clock on the Piaggio MP3 300 HPE
Mp3 300 Today's instructions will allow us to change the time on the display of the instrument panel of the Piaggio MP3 300 HPE scooter. First, we put the sc…
How do you replace the battery of the Piaggio MP3 300?
How do you replace the battery of the Piaggio MP3 300?
Mp3 300 To replace the battery of the Piaggio MP3 300, you will need to open the underseat compartment, using the appropriate key and lifting the seat itself…

How to Replace the Headlight Bulbs on the Triumph Speed Triple 765 R?

In this tutorial, you will see how to replace the headlight bulbs on the Triumph Speed Triple 765 R, a very simple and quick operation. First, ensure that the key is not inserted, then locate the large cap at the back of the headlight and remove it by turning it counterclockwise. Next, disconnect the power connector, unclip the metal clip, and remove the old bulb from the housing. At this point, simply insert the replacement and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos