Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Piaggio Beverly 350
Part:

To replace the belt on the Piaggio Beverly 350, first loosen the bolts securing the protective cover of the casing located near the rear wheel. Once the casing is open, you will have access to the transmission: you will need to unscrew the nut that secures the central pin of the variator and also the one that secures the central pin of the clutch: this will allow you to remove the variator, then the clutch bell and all its discs. This will enable you to slide out the belt and replace it; finally, you can reassemble all the previously removed parts.

Updated on 17 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Belt on the Piaggio Beverly 350?
How to Replace the Belt on the Piaggio Beverly 350?
Beverly 350 To replace the transmission belt on the Piaggio Beverly 350, loosen the screws securing the cover over the rear wheel, located under the one containi…
Replacing the drive belt on the Piaggio Beverly 350
Replacing the drive belt on the Piaggio Beverly 350
Beverly 350 This guide provides instructions for removing and replacing the drive belt on the Piaggio Beverly 350 scooter in simple steps. First, place the scoot…
Removing the Belt and Variator from a Piaggio Beverly 350
Removing the Belt and Variator from a Piaggio Beverly 350
Beverly 350 Let's see how to remove the drive belt and variator from a Piaggio Beverly 350 scooter in simple steps. First, remove the plastic cover from the left…

How to Change the Engine Oil on a Triumph Tiger 900?

To change the engine oil on the Triumph Tiger 900, follow these steps. First, ensure the engine is warm but not too hot. Lift the motorcycle on a centre or side stand to make it stable. Locate the oil drain plug on the engine casing, usually positioned on the lower side of the engine. Place an oil collection container under the drain plug and unscrew the plug to allow the used oil to drain out. Once the oil has completely drained, remove and replace the oil filter. Be sure to lubricate the sealing ring of the new filter before installing it. Reinstall the oil drain plug and ensure it is tightly secured. Next, locate the oil filler cap on the engine and remove it. Fill the engine with new engine oil, using the oil recommended in the owner's manual. Check the oil level using the dipstick and add oil if necessary to reach the correct level. Finally, screw the oil filler cap back on, start the engine, and check for any oil leaks. Recheck the oil level and add oil if necessary. Once the procedure is complete, dispose of the used oil properly at an authorised recycling centre.

Watch the video!


by ScegliAuto

More videos