Do it yourself
| ||||
|
Model: Piaggio Beverly 400
In order to replace the rear brake pads of the Piaggio Beverly 400, you need to loosen the screws that secure the bracket located near the rear wheel, on the right side of the motorcycle: once this bracket has been freed, you can proceed by loosening the screws that secure the brake caliper to the corresponding disc, so that it can be completely detached. After removing the caliper, you can remove the pin that locks the brake pads inside, so that they can be extracted and replaced with new spare parts. After the replacement, you can reassemble all the removed parts.
Posted on 12 February 2024 by ScegliAuto
|
How do you change the engine oil of the BMW R 1200 GS?The replacement of the engine oil of the BMW R 1200 GS is carried out by loosening the bolts that secure the skid plate positioned in the lower part of the bike. Once this plate has been removed, it will be possible to unscrew the drain plug below, so that the used oil can be collected inside a suitably positioned container. Next to the drain plug you will find the oil filter, which in turn must be extracted and replaced with a new one. After the replacement, it will be possible to top up from the special vent on the crankcase to the left of the bike. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.004
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |